// (Parallel Offset)
|
If on, enables control of offset distance and direction of
parallel offset to the original location.
Note: This setting
does not apply to slab forms or free forms.
|
Parallel Offset option menu
|
Sets the offset to a particular side of the original form’s
location:
- Right — Sets the
placement mode as parallel to the right side.
- Left — Sets the
placement mode as parallel to the left side.
|
Placement Offset X, Y, Z
|
Places a form at a different position than its current location,
offset by the values in the X, Y, and/or Z fields.
Each X, Y, and Z placement offset value represents the
difference in coordinates between two points.
- Z — Sets the Z axis
distance between the elevation of the active floor and the elevation of the
item being placed (usually the bottom surface). Base Offset can be a negative
value. Base Offset works relative to the active floor elevation at time of
placement. During instances when the ACS Plane and ACS Plane Snap locks are
turned off, Base Offset is relative to the Active Depth.
|
Define
|
Defines the placement offset direction by placing two data
points.
|
Extrusion Direction X, Y, Z
|
Defines/redefines the sweep direction of a form. The sweep
direction is a vector (X, Y, Z in the global coordinate system) used to sweep
the base shape of the form. During placement when Extrusion Direction is off or
when all values are 0, the sweep direction is perpendicular to the X/Y plane.
|
Define
|
Defines the extrusion direction by placing two data points.
|